- Stainless Steel Electrodes - PHILSTAIN 2209

PHiLARC Products

Certification of Quality

PHILSTAIN 2209

AWS Specification: AWS A5.4 E2209-16

JIS Specification: NO

DIN Specification: DIN 8556 E22 9 3 LR 23

I. APPLICATIONS:

PHILSTAIN 2209 is used for welding duplex stainless steels for high tensile strength and improved resistance to stress corrosion cracking and pitting.

II. DESCRIPTIONS:

For welding of duplex steels

III. NOTES ON USAGE:

Keep the arc length as short as possible.
Choose the welding current within the range stated in the table below.
Do not use excessive current.

IV. TYPICAL CHEMICAL COMPOSITION OF WELD METAL (%):

C	Si	Mn	Cr	Ni	Mo	N
0.02	0.80	0.80	22.00	9.00	3.00	0.14

V. TYPICAL MECHANICAL PROPERTIES OF WELD METAL:

Tensile Strength N/mm²(Ksi)	Elongation %
750 (109)	22

VI. WELDING POSITIONS: FLAT, FILLET, VERTICAL UP, HORIZONTAL, OVERHEAD

VII. SIZES AVAILABLE AND RECOMMENDED CURRENTS (AC or DC + ):

Diameter (mm)		2.5	3.2	4.0	5.0
Length (mm)		300	350	350	350
Ampere	Flat	50 - 80	70 - 110	100 - 150	130 - 180
Ampere	V & OH	45 -75	65 - 105	95 - 140

TEST RESULT

The information contained or otherwise referenced herein is presented only as “typical” without guarantee or warranty, and Industrial Welding Corporation expressly disclaims any liability incurred from any reliance thereon. Typical data and Test results for mechanical properties, deposit or electrode composition and other properties were obtained from a weld produced and tested according to prescribed standards, and should not be assumed to be the expected results in a particular application or weldment. Actual results will vary depending on many factors, including, but not limited to, weld procedure, plate chemistry and temperature, weldment design and fabrication methods. Users are cautioned to confirm by qualification testing, or other appropriate means, the suitability of any welding consumable and procedure before use in the intended application.

philarc-philstain 2209.pdf