- Solid Welding Wire (GMAW and GTAW) - PTS-2209

PHiLARC Products

Certification of Quality

PTS-2209

AWS Specification; AWS A5.9 ER 2209

I. APPLICATIONS:

For welding duplex stainless steels. High tensile strength and improve resistance

to stress corrosion cracking and pitting.

II. DESCRIPTION:

PTS-2209 provides a ferritic austenitic weldment that combines many of the good properties of both ferritic and austenitic stainless steels. Due to the high content of both Cr and Mo a very good resistance to general and pitting corrosion is obtained. The duplex microstructure gives a high tensile strength and hereby also an excellent resistance to stress corrosion cracking.

III. TYPICAL CHEMICAL COMPOSITION OF WELD METAL (%):

C	Si	Mn	Cr	Ni	Mo	N
0.02	0.50	1.60	23.00	8.50	3.10	0.17

IV. TYPICAL MECHANICAL PROPERTIES OF WELD METAL :

Tensile Strength N/mm²(Ksi)

Yield Point

N/mm²(Ksi)

Elongation %

Impact Value

Deg C, J (Deg F, Ft-lbs)

805 (117)

610 (88)

-40°, 170 (-40°,125)

V. SIZES AVAILABLE AND RECOMMENDED CURRENTS:

Diameter (mm)	1.6	2.4	3.2
Length (mm)	1000	1000	1000
Amps	80-110	130-160	160-200

TEST RESULT

The information contained or otherwise referenced herein is presented only as “typical” without guarantee or warranty, and Industrial Welding Corporation expressly disclaims any liability incurred from any reliance thereon. Typical data and Test results for mechanical properties, deposit or electrode composition and other properties were obtained from a weld produced and tested according to prescribed standards, and should not be assumed to be the expected results in a particular application or weldment. Actual results will vary depending on many factors, including, but not limited to, weld procedure, plate chemistry and temperature, weldment design and fabrication methods. Users are cautioned to confirm by qualification testing, or other appropriate means, the suitability of any welding consumable and procedure before use in the intended application.

philarc-pts-2209.pdf