- Submerged Arc Weding Wire and Flux

PHiLARC Products

Certification of Quality

PASF-18 / PASW-EM12K

AWS SPECIFICATION: F7A2-EM-12K

FLUX USED: PASF-18

WIRE USED: PASW EM12K

APPLICATION:

Agglomerated bonded type flux for single pass welding for medium, heavy plates of mild steel and 490N/mm2 H.T. steel, resistibility and excellent weldability. Suits for general steel structure.

TYPICAL ANALYSIS OF ALL WELD DEPOSIT:

C	Si	Mn	P	S
0.09	0.55	1.45	0.016	0.011

TYPICAL ALL WELD MECHANICAL PROPERTIES:

Yield Point

N/mm2 (Ksi)

Tensile Strength

N/mm2 (Ksi)

Elongation

Impact Value

Deg C, J (Deg F, Ft-lbs)

500 (73)

570 (83)

-29,70 (-20,52)

SAW wire diameters available: 2.0, 2.4, 3.2, 4.0, 4.8mm

Packing: 25kg per coil

FLUX Packing: 25kg per bag/sack

Other special requests for packing such as big spools or the like can be accommodated.

TEST RESULT

The information contained or otherwise referenced herein is presented only as “typical” without guarantee or warranty, and Industrial Welding Corporation expressly disclaims any liability incurred from any reliance thereon. Typical data and Test results for mechanical properties, deposit or electrode composition and other properties were obtained from a weld produced and tested according to prescribed standards, and should not be assumed to be the expected results in a particular application or weldment. Actual results will vary depending on many factors, including, but not limited to, weld procedure, plate chemistry and temperature, weldment design and fabrication methods. Users are cautioned to confirm by qualification testing, or other appropriate means, the suitability of any welding consumable and procedure before use in the intended application.