PHiLARC - The No. 1 Choice of Welders

PHILHARD WH2

AWSSpecification: NONE

JIS Specification: NONE

Other Specification: DIN 8555 E2-UM-40-60S

 

I. APPLICATIONS:

heavily lime titania electrode intended for welding worn tools of water hardening, carbon or low-alloy steels. Typical applications are trimming dies for hot and cold work, thread cutting tools, cold heating dies, wood working tools, cold punches, deep drawing, impact extension and embossing tools, and blocks.

     II. TYPICAL CHEMICAL COMPOSITION OF WELD METAL (%):

C

Si

Mn

Cr

Mo

V

0.60

0.40

0.60

0.40

0.80

0.25

III. HARDNESS OF WELD METAL: 60-64 HRC (700-800 Hv)

IV. WELDING POSITIONS: FLAT, FILLET, VERTICAL UP

V. SIZES AVAILABLE AND RECOMMENDED CURRENTS (AC or DC + ):

Size (dia. mm)

3.2

4.0

5.0

Length (mm)

350

350

350

Current Range (Amp)

90 - 130

120 - 180

170 - 230

 

 

TEST RESULT
 
The information contained or otherwise referenced herein is presented only as “typical” without guarantee or warranty, and Industrial Welding Corporation expressly disclaims any liability incurred from any reliance thereon. Typical data and Test results for mechanical properties, deposit or electrode composition and other properties were obtained from a weld produced and tested according to prescribed standards, and should not be assumed to be the expected results in a particular application or weldment. Actual results will vary depending on many factors, including, but not limited to, weld procedure, plate chemistry and temperature, weldment design and fabrication methods. Users are cautioned to confirm by qualification testing, or other appropriate means, the suitability of any welding consumable and procedure before use in the intended application.