PHiLARC - The No. 1 Choice of Welders

PhilCut

AWS Specification: NONE

JIS Specification: NONE

Other Specification:NONE

 

I. APPLICATIONS:

For cutting and piercing all kinds of metals, stainless steels, cast iron and all kinds of non-ferrous metals.

II. DESCRIPTION:

For highest speed, all position cutting and piercing of all metals using standard electric arc equipment. Ideal for cutting and piercing mild carbon steel, stainless steel, cast iron, malleable iron, nickel and nickel alloys, aluminum, copper, bronze. No special skill, supplementary equipment or oxygen tanks are required. Slow burn-off rate leaves little residue, requiring comparably less finishing. PhilCut does not overheat, can withstand high amperage.

III. NOTES ON USAGE:

Mark or scribe line where cut is desired. On DC, use straight polarity. No special holder or compressed air needed. When applying PhilCut electrode, use both the arc-blow, caused by the exothermic coating, plus pressure with the hand. When arc is struck, push and pull, holding electrode at a 45º angle and using a sawing motion to cut. The closer the arc, the faster, cleaner, cooler the cut. For piercing holes, hold PhilCut vertically, and push in and out.

IV. WELDING POSITIONS: FLAT, FILLET, VERTICAL UP, OVERHEAD

V. SIZES AVAILABLE AND RECOMMENDED CURRENTS : AC or DC (+ )

Size

(mm)

Dia.

3.2

4

5

Length

450

450

450

Current Range Amp

150~200

180~250

200~300