PHiLARC Products
- Carbon Steel Electrodes
- High Tensile Strength Steel
- For Low Temperature Steel
- Heat Resisting Steel Electrodes
- Atmospheric Corrosion Resisting
- Hardfacing Electrodes
- Stainless Steel Electrodes
- Nickel and Nickel Alloy Electrodes
- Cast Iron Electrodes
- Aluminum Alloy Electrodes
- Bronze and Copper Alloy Electrodes
- Gouging and Cutting Electrodes
- Solid Welding Wire (GMAW and GTAW)
- Oxy Fuel Gas Filler Rods for Brazing
- Oxy Fuel Gas Brazing FLuxes
- Submerged Arc Weding Wire and Flux
- Flux Cored Wires (FCAW)
PA-8010-G
AWS Specification :A5.5 E8010-G
JIS Specification: NONE
Other Specification: NONE
I. APPLICATIONS:
Transmission and distribution pipelines up to X-70
II. DESCRIPTIONS:
PA-8010-G is a high cellulose electrode designed specifically for vertical down welding of all passes on high tensile pipe. These electrodes are characterized by a steady, forceful, concentrated arc to insure good penetration and wetting action. The slag is fast freezing, minimizing slag interference, and allows for easy control of the weld shape and size.
III. NOTES ON USAGE:
The root pass is deposited in the vertical down position. A drag technique is used and the electrode is pressed tightly into the joint. The second or hot pass should be deposited as soon as possible after the root pass. The current should be high enough to burn out any possible wagon tracks or slag. A slight weaving technique is usually employed. The filler passes are applied using a weaving technique in order to completely fill the joint. Excessive travel speed should always be avoided to lessen any chance of porosity. Pre-heat and interpass temperatures between 300ºC and 400ºC are recommended.
IV. TYPICAL CHEMICAL COMPOSITION OF ALL WELD METAL DEPOSITS (%):
C |
Mn |
S |
P |
Si |
Ni |
0.15 |
1.0 |
0.018 |
0.011 |
0.20 |
0.25 |
V. TYPICAL MECHANICAL PROPERTIES OF ALL WELD METAL DEPOSITS:
Yield Point N/mm2 (ksi) |
Tensile Strength N/mm2 (ksi) |
Elongation % |
Impact Value °C, J (°F, Ft-Lbs) |
510 (74) |
635 (92) |
29 |
-29°, 68 (-20°, 50) |
VI. WELDING POSITIONS : ALL POSITIONS
VII. SIZES AVAILABLE AND RECOMMENDED CURRENTS
SIZE (MM) |
Diameter (mm) |
3.2 |
4.0 |
5.0 |
Length (mm) |
350 |
400 |
400 |
|
CURRENT A |
F & VD |
70-110 |
120-160 |
160-200 |
VU & OH |
60-100 |
110-150 |
130-170 |